What F24 (110 / Whirlpool-built front-load) Means
F24 on the Whirlpool-built 110-prefix front-load platform means the water temperature sensor circuit is not reporting believably, so the control cannot tell how warm the tub actually is and refuses to manage a heated cycle blind.
Common Causes of F24 (110 / Whirlpool-built front-load)
- A temperature sensor that has drifted out of specification
- A broken wire between the sensor and the display control board
- Connector corrosion where the sensor harness plugs in
🔧 One Safe Check You Can Try
Try a cold-only cycle; if it completes while every heated selection stops, that supports a temperature-sensing fault rather than anything wrong with the wash system.
⚠ Why You Shouldn't Go Further Than That
- Sensor resistance is read with the washer isolated, because the circuit runs beside the heater wiring that carries full mains voltage.
- A sensor replaced without checking its harness commonly reproduces the identical code.
- Panel access to reach the sensor may affect any coverage you still hold — check the terms first.
Opening a panel to inspect or repair something yourself doesn't automatically cancel your manufacturer's warranty — but it can risk accidental damage, and some manufacturers do have specific service conditions. Check your product's warranty terms, or ask us, before deciding.