Kenmore Repair Specialists. Same-Day Service.
From a refrigerator that won't cool to a wall oven that's been in the kitchen for fifteen years — our licensed technicians know Kenmore's appliances inside and out, whichever era or manufacturer actually built yours, backed by a workmanship guarantee on every job.
Book Your Repair Today
Same-day & next-day appointments · No hidden fees · Technicians trained on these appliances
or call (844) 621-1345 now
Full-Service Kenmore Appliance Repair
One call covers diagnostics, repair, and follow-up — for every major Kenmore appliance in your home.
Multi-Unit & Property Manager Service
One point of contact, consolidated invoicing, and technicians who already know your building's Kenmore appliance mix.
Learn more →
Warranty Repair Support
A straight answer on whether your repair belongs under Kenmore's coverage or ours.
Learn more →
Installation & Setup
Correct leveling, hookups, and connections so a new Kenmore appliance performs the way it's supposed to from day one.
Learn more →
Preventive Maintenance
A once-a-year check catches the small stuff — clogged filters, worn seals, blocked vents — before it turns into a breakdown.
Learn more →
Diagnostics & Error Code Troubleshooting
We identify which manufacturer actually built your Kenmore unit, then diagnose it correctly the first time.
Learn more →
Same-Day Repair
Call before early afternoon in most cases and a technician is on your doorstep before the day is out.
Learn more →We Repair Every Major Kenmore Appliance
Select your appliance to see common problems, error codes, and book a technician.
Recognize the Warning Signs
These are the issues we get called about most. If any of this sounds familiar, it is worth a diagnostic visit before the problem gets worse.
Refrigerator not cooling
A warm fridge, a compressor that won't stop running, or frost buildup in a frost-free freezer usually traces back to a specific relay, fan, or seal — not a reason to replace the whole unit. See likely causes →
Dishwasher leaves standing water
A blocked filter or a failing drain pump is behind most Kenmore dishwashers that finish a cycle with water still in the bottom. See likely causes →
Washer won't finish its cycle
A worn door lock or a tripped load-balance sensor is the most common reason a Kenmore washer stalls partway through. See likely causes →
Dryer runs but won't dry
Clothes coming out damp after a full cycle is almost always a blocked vent or a failing heating element, and a blocked vent is worth fixing quickly for fire-safety reasons alone. See likely causes →
Oven won't hold its temperature
Uneven baking or an oven that drifts off its set temperature usually points to a worn sensor, not a unit on its way out. See likely causes →
Unfamiliar code or light on the display
Kenmore appliances have been built by more than one manufacturer over the years, so we start by confirming which one built yours before reading into what the display is telling you. See likely causes →
Why Homeowners Trust Us With Their Kenmore Appliances
We Identify Who Actually Built It
Kenmore appliances have come from several different manufacturers over the decades — we confirm which one before we start, so the diagnosis and parts are right the first time.
OEM-Grade Replacement Parts
We install manufacturer-correct parts for the specific era and maker behind your unit, not generic substitutes.
Booked Fast, Not "Sometime This Week"
Most calls across our five metro areas get a same-day or next-day slot with a real arrival window.
One Price, Set Before We Start
You see and approve the cost before any repair begins — nothing changes once the job is open.
Licensed & Insured on Every Visit
Every technician who comes to your door is fully licensed and insured, no exceptions.
Backed by Our Workmanship Guarantee
If the same issue comes back within 30 days, we come back too, at no charge.
Why a Kenmore Specialist Beats a General Repair Shop
A Kenmore specialist focuses exclusively on Kenmore appliances, carries Kenmore-specific parts in every service vehicle, and trains technicians specifically on Kenmore diagnostic procedures. A general repair shop works across dozens of brands and often doesn't stock parts — or carry deep expertise — for a less common model.
| Capability | Us · Kenmore Specialist | General Repair Shop |
|---|---|---|
| Kenmore parts in stock | Always | Sometimes |
| Kenmore-trained technicians | Every tech | Maybe one |
| Knows current + legacy models | Every series | Limited |
| Repair warranty included | 30 days | Varies |
| Background-checked technicians | Required | Varies |
Proudly Serving Five Major Metro Areas
Every city page below is built for your local address, crew, and response time — not a generic template.
What Kenmore Owners Say About Us
“Our Kenmore fridge in Kendall started running nonstop back in late spring, never cycling off like it used to. Figured a unit that old was simply done for. Technician pulled the model number, told us it was actually a Whirlpool-built unit under the hood, and replaced a failing start relay in about forty minutes.”
“Booked a visit for our Kenmore dishwasher in Pinecrest when it started leaving a puddle at the bottom after every load sometime around March. Assumed the pump was shot. It was the lower filter, completely clogged, cleaned out in minutes and no charge for the diagnostic since it took so little time.”
“Our washer in a North Miami laundry room quit halfway through the spin cycle a few weeks back, over and over. I braced for a whole new machine. Door lock switch had failed, replaced same visit, hasn't skipped a cycle since.”
“Our old Kenmore wall oven in Coral Gables started baking unevenly sometime last winter, burnt on one side every time. Thought it was finally time to remodel the kitchen around a new one. Temperature sensor, replaced in one visit, bakes evenly again.”
“Our range in Sherman Oaks had a front burner that just clicked and clicked without ever lighting, this went on for about a week before we called. Assumed the whole cooktop needed replacing. Worn igniter, swapped out fast, lights on the first try now.”
“Our Kenmore dryer in Culver City was taking three cycles to dry anything by the time we called, sometime around early summer. I was worried about the fire-risk angle I'd read about online. Vent was almost completely blocked with lint, cleared out, one cycle does it now.”
“Our over-the-range microwave in Glendale stopped heating altogether a couple months back, fan and light still worked fine though. Figured that meant a full replacement given how it's built into the cabinet. High-voltage diode had failed, replaced without touching the surrounding cabinetry at all.”
“Our refrigerator ice maker in Long Beach stopped producing ice sometime around the holidays last year, water dispenser still worked though. Assumed the whole ice maker unit needed swapping. Frozen water line, thawed and insulated properly, making ice again within the hour.”
“Our dishwasher in Katy started humming loudly without actually washing anything back in late summer. Thought the motor had burned out entirely. Turned out a utensil had jammed the spray arm, cleared it, runs quiet again.”
“Booked for our Kenmore range in Sugar Land when the oven side stopped heating past a certain point sometime this past spring, cooktop was fine. Assumed it needed a whole new control board. Just the bake element, replaced quickly, oven runs at full temperature now.”
“Our washer in Pearland started shaking hard enough to move across the floor during spin sometime around Thanksgiving. I figured the drum bearing was gone for good. Load-balance sensor had failed, not the bearing at all, fixed same visit.”
“Our old Kenmore cooktop in Spring had one electric burner that just wouldn't heat up no matter the setting, noticed it a few weeks before finally calling. Assumed we'd need a whole new cooktop given its age. Bad switch behind that one burner, replaced, works like the rest of them now.”
“Our fridge in a Park Slope brownstone kitchen started buzzing loud enough to hear from the next room sometime over the winter. I assumed the compressor was failing after all these years. Evaporator fan motor, not the compressor at all, quiet again after the swap.”
“Our dryer in a Murray Hill apartment building shut off mid-cycle repeatedly starting sometime last fall, always with damp clothes still in the drum. Thought the motor was on its way out. Overheating thermostat tripping early from lint buildup, cleared and reset, finishes cycles fully now.”
“Our Kenmore dishwasher in a Riverdale kitchen wouldn't start at all one morning, no lights, nothing, sometime around late winter. Figured the control board had died. It was the door latch switch not registering closed, replaced, starts every time now.”
“Our wall oven in a Forest Hills kitchen had a door that wouldn't unlock after a self-clean cycle sometime this past year, stuck for nearly a full day before we called. Assumed we'd need to force it open somehow. Power cycled it and reset the lock mechanism, opened right up, no damage done.”
“Our range in Point Loma had a burner flame that kept dancing unevenly and occasionally going out sometime around late spring. Thought the whole gas valve needed replacing. Clogged burner port, cleaned out in minutes, flame's steady now.”
“Our Kenmore washer in Carmel Valley started leaking a small puddle underneath sometime a few weeks back, only during the fill part of the cycle. Assumed a hose had burst somewhere inside. Just a loose supply-line fitting, tightened up, dry since.”
“Our microwave in La Jolla started sparking inside during a reheat sometime this past winter, stopped using it immediately like the manual says to. Technician found a small metal fleck stuck to the cavity wall from a scrubbing pad, cleaned it out, no damage to the magnetron at all.”
“Our refrigerator in Rancho Bernardo was warmer than the display setting for what felt like a couple weeks before we called this past summer. Assumed a full sealed-system leak. Turned out to be a worn door gasket letting warm air in, replaced, temperature's correct again.”
Your Kenmore Appliance Doesn't Have to Wait
Book online in under a minute, or call now and talk to a real technician — not a call center script.
Frequently Asked Questions
Our technicians specialize in Kenmore appliances and are trained specifically on Kenmore engineering, control boards, and error-code diagnostics, so repairs are faster and more accurate than a generalist visit.
Most requests in Miami, New York, Houston, Los Angeles, and San Diego are scheduled same-day or next-day, depending on your neighborhood and time of day you call.
The diagnostic fee is disclosed upfront when you book and is waived when you approve the repair, so there is never a surprise on your invoice.
Let us know when you book - we will help you understand your options, and if it is more cost-effective to route the claim through Kenmore directly, we will tell you honestly.
Our technicians stock the most common Kenmore parts for your appliance type, so the large majority of repairs are completed in a single visit.
Book online or call in, and a technician arrives in the window we give you. They diagnose the problem on-site, walk you through what is actually wrong, and give you a flat price before any repair starts - nothing happens until you say go.
Every completed repair carries a 30-day workmanship warranty. If the same issue comes back in that window, we return and fix it at no charge. Parts may carry the manufacturer warranty where applicable.
Miami, New York, Houston, Los Angeles, and San Diego, plus the surrounding neighborhoods in each metro. Check your city page for local response times and the specific areas we cover.
Yes - every technician we send is licensed, insured, and background-checked before they are allowed on a job. You can ask to see credentials on arrival.
We are open 7:00 AM - 8:00 PM on weekdays and 8:00 AM - 6:00 PM on Saturdays. Sunday availability is limited to emergency calls only - mention the urgency when you book and we will do what we can.