What F22 (110 / Whirlpool-built front-load) Means
F22 on the Whirlpool-built 110-prefix front-load platform means the door lock assembly did not confirm that it had locked. Because a front-loader will not add water until the door is proved shut, this code stops the cycle before anything else can happen.
Common Causes of F22 (110 / Whirlpool-built front-load)
- Laundry trapped in the door seal holding the door off its catch
- A failed door lock assembly that no longer confirms engagement
- A wiring fault between the lock and the main control board
🔧 One Safe Check You Can Try
Press the door firmly closed against the seal and listen for the lock to click over; a bulky item pressed against the boot seal will hold the door a fraction open, which is enough.
⚠ Why You Shouldn't Go Further Than That
- The lock assembly is wired directly into the main board and sits behind the front panel, so it is isolated before it is touched.
- Bending the striker to make the door catch harder tends to crack the lock body instead.
- A lock swapped while the harness is the actual fault leaves the code exactly where it was.
Opening a panel to inspect or repair something yourself doesn't automatically cancel your manufacturer's warranty — but it can risk accidental damage, and some manufacturers do have specific service conditions. Check your product's warranty terms, or ask us, before deciding.