What Start/Resume Blinking / Clean Light Steady / Control Lock LED (665 / Whirlpool-built) Means
Three 665-prefix Kenmore behaviours that owners routinely mistake for breakdowns: a slowly blinking Start or Resume light after the door was opened or power was interrupted mid-cycle, a Clean light that stays on because the control never saw the door opened after the last cycle, and a Control Lock LED that has been switched on by accident.
Common Causes of Start/Resume Blinking / Clean Light Steady / Control Lock LED (665 / Whirlpool-built)
- A cycle interrupted by the door being opened or by a power blip
- The door never opened between cycles, so the Clean light stays lit
- The control lock enabled accidentally while wiping the panel
🔧 One Safe Check You Can Try
Close the door firmly and press Start or Resume for the blinking light; for the control lock, hold the Heated Dry key for five to ten seconds, which is the documented release on this platform.
⚠ Why You Shouldn't Go Further Than That
- None of these three is a fault, so opening the machine achieves nothing and risks creating one.
- If holding Heated Dry does not release the lock, the keypad itself is the suspect rather than the lock feature.
- Cycling the breaker repeatedly to clear a Clean light simply adds another interrupted cycle to the count.
Opening a panel to inspect or repair something yourself doesn't automatically cancel your manufacturer's warranty — but it can risk accidental damage, and some manufacturers do have specific service conditions. Check your product's warranty terms, or ask us, before deciding.